Hello!
On Tue, Feb 16, 2016 at 11:29:32AM -0500, Alt wrote:
> Hello,
>
> To use pcre_jit ( http://nginx.org/r/pcre_jit ), is it mandatory to compile
> nginx with "--with-pcre-jit"?
> On FreeBSD, nginx isn't compiled with "--with-pcre-jit", but I can still use
> "pcre_jit on;" without nginx throwing errors. So, does nginx really use PCRE
> JIT in this case?
>
> This bug report: https://bugs.freebsd.org/bugzilla/show_bug.cgi?id=200793
> mention "--with-pcre-jit" isn't needed.
Sergey Osokin's response is correct.
The "--with-pcre-jit" is only needed when you compile PCRE library
using nginx configure (./configure --with-pcre=<path> ...). When
using a system PCRE library whether or not JIT is supported
depends on how the library was compiled.
On FreeBSD PCRE is compiled with JIT enabled except on few archs
where it's not available.
If you'll try to use "pcre_jit on" without JIT available, nginx
will warn you during configuration parsing:
nginx: [warn] nginx was built without PCRE JIT support in ...
Or, if nginx was compiled with JIT available, but currently loaded
PCRE library does not support JIT:
nginx: [warn] PCRE library does not support JIT in ...
If you don't see these messages - this means that JIT is used.
--
Maxim Dounin
http://nginx.org/
_______________________________________________
nginx mailing list
nginx@nginx.org
http://mailman.nginx.org/mailman/listinfo/nginx