If this is on a linux host. "cat /proc/<nginxpid>/status".

Look at value for FDSize.

Sridhar



On Fri, Apr 1, 2011 at 4:58 PM, Richard Kearsley
<Richard.Kearsley@m247.com>wrote:

> Hi
> Thank you, I will try this.
>
>
> -----Original Message-----
> From: Igor Sysoev [mailto:igor@sysoev.ru]
> Sent: 01 April 2011 21:49
> To: nginx@nginx.org
> Subject: Re: 24: Too many open files
>
> On Fri, Apr 01, 2011 at 04:08:30PM +0000, Richard Kearsley wrote:
> > Hi
> > Thanks for the reply.
> >
> > The only references to worker in my config are:
> >
> > worker_processes 4;
> > events
> > {
> > worker_connections 4096;
> > }
> >
> > I read in nginx wiki if worker_rlimit_nofile is not defined, the value
> from ulimit -n is used?
>
> "ulimit -n" sets/shows the limit of you current login session.
> If you run nginx in this session, it will inherit this value.
> If it run at bootstrap or something else the limit may be other.
> The simplest way is to set it in nginx.conf:
>
> worker_processes 4;
> worker_rlimit_nofile 100000;
>
>
> --
> Igor Sysoev
> http://sysoev.ru/en/
>
> _______________________________________________
> nginx mailing list
> nginx@nginx.org
> http://nginx.org/mailman/listinfo/nginx
>
> _______________________________________________
> nginx mailing list
> nginx@nginx.org
> http://nginx.org/mailman/listinfo/nginx
>
_______________________________________________
nginx mailing list
nginx@nginx.org
http://nginx.org/mailman/listinfo/nginx