<648405.56936.qm@web46309.mail.sp1.yahoo.com>

On Thu, 2009-03-19 at 15:01 -0700, Rt Ibmer wrote:
> I use nginx 0.6.31 with proxy_pass to front end requests to a servlet
> running in Jetty (the upstream).
>
> Sometimes I need to update a jar on the upstream, which requires
> restarting jetty to take effect.
>
> I am looking for a way to tell nginx that if it gets a connection
> failure at the upstream (which is what happens when jetty is in the
> process of restarting since nothing is listening on that port during
> the restart) that it should give it say 20 seconds before erroring out
> the request back to the browser.
>
> Certainly this will back up the processing a bit, but it should be
> very short as it only takes Jetty about 10 seconds to restart and
> start listening again on its port. During slow periods we are only
> getting 2-5 requests per second so there should be plenty of resources
> for nginx to queue up these requests while it waits for Jetty.
>
> Can someone please tell me what settings I should use so that nginx
> will wait up to 20 seconds for the upstream to restart so that it
> doesn't return an error to the browser?
>
> In the past I have tried setting all these to 20 seconds:
> proxy_connect_timeout 20s;
> proxy_send_timeout 20s;
> proxy_read_timeout 20s;
>
> but when I restarted Jetty, right away the nginx error logs started
> showing errors like:
> [error] 6445#0: *141102686 connect() failed (111: Connection refused)
> while connecting to upstream

That's because there is nothing to connect to, which is different than a
timeout. The backend socket is closed rather than open but
unresponsive.

> Are the above configuration parameters correct for what I am trying to
> do and maybe I just didn't set them right? Or is there some other way?
>
> Basically what I'm trying to do is set those settings high, tell nginx
> to reload its config, then bounce jetty, then have nginx hold the
> requests long enough to get through once jetty is back up and then
> have the requests go through to jetty without losing any requests.
> Then after jetty is restarted I would put the timeouts back to normal
> levels like 3s, until the next time I have to do an update.

Have you considered running two instances of Jetty rather than just one?
Then you could use the upstream directive to manage this.

Regards,
Cliff