Hi,
I hope that I am posting at the right place.
I am trying to figure out if multi-thread mode is supported with the
latest release, and if so then what I need to do for using it?
I am trying to compile it from its source code for PowerPC architecture.
But I have seen that the following is been commented out in the
auto/options file.
#--with-threads=*) USE_THREADS="$value" ;;
#--with-threads) USE_THREADS="pthreads" ;;
Due to which I am bit confused if its supported or not!
--
Regards
Nitesh Narayan Lal
http://www.niteshnarayanlal.org/
_______________________________________________
nginx mailing list
nginx@nginx.org
http://mailman.nginx.org/mailman/listinfo/nginx